...

Yellow linoleum floors

Here is a question I received by email recently, the answer may help others with similar potential issues….

I removed a rubber backed mat from my white floor in front of my kitchen sink, and the area under the mat has turned yellow. What will remove this stain?

The short answer is nothing. It is likely a linoleum floor, which as a result of have moisture trapped under the mat, has left this permanent yellowing. There is no way to remove this type of stain. The best solution is yet another mat to hide the stain, or to replacing the flooring. A jute or natural backed mat will permit moisture to escape, and will not cause further damage.

Removing lint and wrinkles

Removing lint can be done a few ways the fastest and easiest is a rolled up piece of tape, use duct or packing tape to have more sticky surface area, or use a slightly dampened sponge, or clothes or lint brush works too…

Removing unwanted wrinkles when you don’t have easy access to an iron, hang clothes in the washroom when having a shower, keep the doors and windows closed and leave the fan off.  You can also place the clothes in the dryer with a damp towel for 10 minutes to remove wrinkles as well.

Mildew on clothes

Prevent mildew on clothes by storing them correctly.  Always be sure they are 100% dry before storing.  Avoid storing in plastic bags or boxes, which can trap moisture.  Ventilate storage areas when the weather is good or the opportunity presents.  Pack storage areas loosely allowing air to circulate.  Don’t use starch or fabric softener on items to be stored.  Use a chemical desiccant (absorbs humidity) like packaged silica gel to absorb humidity.

Smoke damage

Someone recently sent an email asking about removing smoke damage, first most of the time a professional should be called when repairing smoke damage.  For a small amount of smoke damage you can use a soot sponge, found at any professional janitorial supply store.  Soot sponges are also effective at removing pet hair from upholstery.

How to make whites, whiter…

Whites, whiter…

My white clothes look dull and dingy. Most of the labels say “NO Chlorine Bleach” – is there another way to whiten them?

There are many reasons for whites to become dull. A very common factor is hard water. The trace elements in the water can prevent soap from lathering properly and the residue can leave a dull or gray appearance. Check with your local utility to see if this is a concern. For slightly hard water, it is possible to overcome the problem of siding, by simply adding more detergent.

You can try an all fabric bleach (Bleach for un-bleachable), or an oxygen bleach, but always test for color fastness on the clothing, and add the bleach to the soap and water, BEFORE adding the clothing. Even these ‘safe’ bleaches can cause damage if poured in concentrate, directly onto wet clothing.

You might also try soaking in a solution of water and lemon juice overnight before washing. Then add this soak water into the wash water with the regular detergent when washing.

The final tip would be to hang these articles to dry in the sun. The sun is an excellent natural bleaching tool, which can actually even lighten some stains to the point they are invisible. The other huge benefit of air drying, along with the fact it is free, is that stained clothing will not have the stain ‘set’, whereas a tumble dryer gets so hot, that the stains are baked into the fibers.

Ink stains in dryer….

This question was submitted by Tammy;
A pen got into the dryer how do I remove the ink?

Conveniently one of Forum experts had the same thing happen to him not very long ago.

Tools & Techniques:
Clean dry cleaning rags, multi use solvent.

1. First do NOT run the dryer anymore heat absolutely sets ink stains.
2. Using a clean dry cleaning rag wipe as much ink off as possible. If you catch before the heat has set this then you have a chance.
3. In my case there was an extreme amount of ink and I wiped what I could. Next I got progressively more aggressive with my cleaning compounds. I started by using a large towel and poured a mixture of warm water and dish soap on the towel and placed in the drum in an attempt to have some of the ink soak into the towel since there was so much ink. I had marginal success with that, but I was able to get some off and especially where there was a large amount of ink.
4. Then I used a multiuse solvent designed to break down gum, glue, ink etc. (solvents are flammable use caution be sure the dryer is cool, be sure there is very good ventilation when working). Pouring the solvent on my clean dry white cleaning rags I slowly worked on my dryer drum using allot of cleaning rags I was able to remove allot of the ink.
5. The problem I was having was ink under the agitators (usually plastic). The ink on the plastic came off well with the solvent, but ink had pooled under the agitators. I poured a general purpose cleaner along the edge and a fair bit of ink came out. I did not pour the solvent since I did not want to much flammable material to be used.
6. The key was I took my time and used allot of rags always pouring the solvent on them and removing as much ink as possible.
7. Now I had so much ink that I eventually used paint thinner to remove more ink. Now paint thinner is also very flammable so I used with caution. I did not nor would I recommend running the dryer for at least 24 hours, waiting for all the vapour to dissipate first. This is why I did not pour the solvent directly into the drum.
8. Now all this took some time and effort and after it was all done I did not even get 100% of the ink removed only about 70% so I was a little frustrated. After about 24 hours I ran the dryer only on air fluff to be sure there was no vapour. And I washed and dried some work clothes to absorb any ink that may not have come off.
9. It has been a couple months now and it looks like a little more ink has come off but I have seen absolutely no ink on any clothes. To summarize be patient and realize that it probably will not be perfect and you will have to live with some ink stains on your dryer drum but overall it will have no impact on your dryers performance. I will NEVER again forget to remove my pens from my pocket (I hope…) this was one tough job. Good Luck

General Information: How to blot…

General Information: How to blot…

It sounds silly but this cleaning technique is critical to removing many household stains.
Blotting is the act of absorbing a stain with a dry absorbent towel such as a terry towel or even a paper towel (best using white towels so no colors from the towel will run into the carpet or fabric you are blotting.) Blotting immediately after a spill or stain has occurred is the best way to combat stains. Blot by placing the towel over the stain. First fold your towel in quarters so you can flip over the towel a few times to get the maximum absorbency of your towel.

Do’s and Don’ts of stain removal

General Spot Cleaning Tips

DO

Use a clean white, absorbent terry towel.
Blot or tamp the spot.
Pretest the carpet in an inconspicuous area.
Clean the stain from the edge to the center.
Apply cleaner to the towel.
Clean with modest amounts of cleaning solution.
Adhere to product safety and follow instructions.
Remove the stain as soon as it is noticed.
Remove the dirty excess before cleaning.
Use cleaning compounds at lukewarm temperature.

 

DON’T

Use a dirty or coloured rag.
Rub, brush or scrape the spot using force.
Pretest the carpet in the middle of the room.
Clean the stain from side to side.
Apply cleaners directly to the stain.
Saturate the spot with cleaners.
Ignore manufacturers instructions.
Ignore the stain or leave it until later.
Wet clean before removing the dry excess.
Apply heat to the stain.

Not all stains can be completely removed, but appearances can be improved.

error

Enjoy this website? Please spread the word :)

Instagram
Follow by Email
RSS